How to Link Your Smart Lock and Video Door Phone for Seamless Access
Combining smart lock and door phone makes access secure and easy. Here’s how to link them:
Pre‑Check:
• Make sure both devices support integration (same brand or compatible protocol, e.g. RS‑485, Wiegand).
• Have manual and any required firmware updates ready.
Step 1: Use Appropriate Wiring
Connect the lock’s control wires from the door phone panel to the smart lock’s input terminal. Follow wiring diagrams closely.
Step 2: Power On & Pair
Power up both devices. On your door phone’s menu, go to Access Control → Add Lock. Press unlock to test.
Step 3: Configure Time & Access Settings
Set auto‑unlock times, PINs, temporary codes, and remote unlock via monitor or app.
Step 4: Smartphone/App Controls
If supported, install the brand’s mobile app. Pair both devices and enable remote unlock or guest PIN features.
Step 5: Final Testing
Test setup by ringing panel, verifying visitor, then unlocking via monitor—and optionally via the app.
Troubleshooting Tips:
• No unlock? Check wiring and voltage.
• Weak audio/no video? Firmware may need updating.
• Lock doesn’t operate? Check output relay settings in panel menu.